6017 bearing

6017 bearing size: 85 * 130 * 22mm, inner diameter: 85mm, outer diameter: 130mm, thickness: 22mm. At present, 6017 bearings are widely used in transmission gears, machine tool accessories, distillation equipment, power station boilers, gas valves, extruders, bridges, and automotive lamps.

Similar to the 6017 bearing model, there are bearing 16010, deep groove ball bearing 6010, bearing 6010.2RSR, deep groove ball bearing 6010.2ZR, deep groove ball bearing 16011, bearing 6011, deep groove ball bearing 6011.2RSR, bearing 6011.2ZR, deep groove Ball bearing 16012, bearing 6012, and the like.

When installing the 6017 bearing, it should be noted that the installation condition is one of the primary factors in the use factor. The bearing is often changed due to improper installation, and the force state between the parts of the whole bearing changes, and the bearing operates under abnormal conditions. And the early end of the service life factor mainly refers to the three major factors that determine the bearing quality, such as structural design, manufacturing process and material quality. According to the technical requirements of bearing installation, use, maintenance and maintenance, the load and speed of the bearing in operation The working temperature, vibration, noise and lubrication conditions are monitored and checked. If an abnormality is found, the cause is immediately found and adjusted to make it return to normal.

Some problems to be noted when using the 6017 bearing after installation:

1. Open the bearing packaging too early before use, causing pollution; the working environment is not clean during installation, causing pollution; the working environment of the bearing is not clean, and the working medium is polluted.

2. Angular contact ball bearings can withstand both radial and axial loads.

3, the bearing seal can be divided into two types of self-contained seal and external seal.

4. The fiber displacement sensor has high sensitivity; the signal is directly extracted from the bearing surface, and the signal to noise ratio is improved;

5, there are very few high-speed light cutting milling machines, after the spindle motor is used, the rear bearing spindle.